North Star 999883 Owner's Manual page 29

4. Verify connection
5. Attach remote switch
to vehicle
6. Disconnect after use
7. To disconnect
permanently
Assembly
Verify a complete connection has been made by checking with a DC voltmeter,
or by briefly turning the remote switch to the ON position and listening for pump
activation.
Using supplied Hook & Loop pad, affix remote switch to vehicle in a position
that is easily reached from the driver's seat.
AFTER EACH USE, disconnect power to the sprayer by disconnecting the
sprayer's pump cord from the remote switch – the remote switch may remain
connected to the battery.
NOTE: It is important to disconnect power to the sprayer when not in use for
safety reasons. ALWAYS verify that the power has been disconnected or the
remote switch is in the OFF position before adding chemicals or servicing.
When it is necessary to disconnect the sprayer's remote switch from the
battery, use the following procedure:
1. Disconnect sprayer's pump cord from the remote switch.
2. Disconnect the remote switch from the vehicle battery as follows:
a) Disconnect vehicle battery ground wire.
b) Disconnect the remote switch's black battery clamp from the
negative (-) terminal of the vehicle battery.
c) Disconnect the remote switch's red battery clamp from the positive (+)
terminal of the vehicle battery.
d) Reconnect the vehicle battery ground wire.
WARNING: Always disconnect in this sequence to avoid possible shock.
(Remember that on some vehicle models, you may need to remove the sprayer to
access the battery)
29