North Star 999883 Owner's Manual page 20

Step 8 – Pump to Tank Assembly
• Apply soap to bypass fitting on regulator.
• Press bypass fitting into the grommet.
• Install (1) long screw through tether, washer and front left
pump foot and into threaded hole in tank until tight.
• Install (3) short screws through washers and pump feet and
into threaded holes in tank until tight. Note: damage to
rubber pump feet could occur if screws are over-tightened.
Fasteners Needed from Owner's Manual Bag:
Screw, #10-24 x 1 1/8
Qty 3
82061
Tether
Assembly
" Screw, #10-24 x 1 1/4
Qty 1
82617
20
Tools Needed
• Phillips head
screwdriver
#10 Washer
"
Qty 4
82068
Screw, #10-24 x 1 1/4
"
"
Screw, #10-24 x 1 1/8
Washer