Datamax H-4212X Operator's Manual page 87

Displayed Message
REMOVE RIBBON
PRESS ANY KEY
SAVE CHANGES?
SUCCESSFUL
PRESS ANY KEY
SYSTEM RESET
IN PROGRESS
UNCALIBRATED
WAITING FOR DATA
WAITING FOR SIGNAL
XXXX OF XXXX
PRINTING
H-Class
Prompts and Condition Messages (continued)
Description
The TEST Button was
pressed and held, or CLEAN
HEAD NOW was selected.
Database changes were
made that require
confirmation.
The operation was
successfully completed and
now requires confirmation.
A reset via the host system
or the Control Panel has
occurred.
The Media Sensor is not
calibrated.
Start of Print signal has
been received, but the
printer awaits label data.
The printer awaits a Start of
Print signal from the host.
The print job is underway.
Action / State
Ribbon must be removed
and a key pressed to
proceed with cleaning.
Press YES to accept the
changes, or NO to discard
them.
If changes require a
reset, it will automatically be
invoked.
Press any key to continue.
Allow the process to
complete.
Perform calibration; see
Section 5.2.
Send data from the host.
Send the Start of Print
signal to the GPIO port from
the host.
The batch total and
remaining label count are
displayed.
77