Datamax H-4212X Operator's Manual page 49

Print Control (continued)
Menu Item
PRESENT DISTANCE
AUTO 0.00 (0 – 4.00 in.)
CUSTOM ADJUSTMENTS ♦
DARKNESS
32 (1 – 64)
CONTRAST
32 (1 – 64)
ROW ADJUST
–
0000 DOTS ( XXX – XXXX)
COLUMN ADJUST
–
000 DOTS ( XXX – XXX)
PRESENT ADJUST
–
000 DOTS ( XXX – XXX)
H-Class
Sets the label stop position, where:
Is the label output distance. The default setting (Auto)
configures this distance according to the positioning
requirements of the attached device (e.g., tear bar,
cutter, etc).
When set to 0.01 in., NONE is assumed; a zero (0)
positioning value will be used.
These selections independently change the listed
parameters, allowing slight mechanical compensations
sometimes evident when multiple printers share label
formats or for special printer-specific formatting
adjustments, where:
Controls the printhead strobe time (see HEAT, above)
to fine-tune the solid areas of an image.
Fine-tunes the gray areas of an image.
Shifts the vertical start of print position upward or
downward to fine-tune ROW OFFSET; see Appendix B.
If shifting in the negative direction, modify
PRESENT ADJUST (see below) by the same
amount.
Shifts both the horizontal start of print position and the
LABEL WIDTH termination point to the right to fine-
tune COLUMN OFFSET; see Appendix B.
Adjusts the label stopping position to fine-tune
PRESENT DISTANCE; see Appendix B.
Details
39