Installing the power button board
Steps
1. Place the power-button board into the slot on the palmrest and keyboard assembly [1].
2. Replace the single (M2x2) screw that secures the power button board to the palmrest and keyboard assembly [2].
3. Affix the conductive tape to the power button board [3].
4. Slide the power button cable to the system board and close the latch to secure the cable [4].
Next steps
1. Replace the
display assembly
2. Replace the
system fan
3. Replace the
WLAN
4. Connect the battery cable to the connector on the system board.
5. Replace the
base cover
6. Replace the
optical drive assembly
7. Replace the
SD memory card
8. Follow the procedure in
System board
Removing the system board
Prerequisites
1. Follow the procedure in
2. Remove the
SD memory card
3. Remove the
base cover
4. Remove the
battery
after working inside your computer
before working inside your computer
Removing and installing components
57