Next steps
1. Replace the
WLAN
2. Connect the battery cable to the connector on the system board.
3. Replace the
base cover
4. Replace the
optical drive assembly
5. Replace the
SD memory card
6. Follow the procedure in
Power-button board
Removing the power button board
Prerequisites
1. Follow the procedure in
2. Remove the
SD memory card
3. Remove the
optical drive assembly
4. Remove the
base cover
5. Disconnect the battery cable from the connector on the system board.
6. Remove the
WLAN
7. Remove the
system fan
8. Remove the
display assembly
Steps
1. Open the latch and disconnect the power button board cable from the system [1].
2. Peel the conductive tape off the power button board [2].
3. Remove the single (M2x2) screw that secures the power button board to the palmrest and keyboard assembly [3].
4. Lift the power button board, along with the cable off the palmrest and keyboard assembly [4].
56
Removing and installing components
after working inside your computer
before working inside your computer