Miele KM 7404 FX Operating And Installation Instructions page 30

Before using for the first time
Con@ctivity via a direct Wi-Fi
connection (Con@ctivity 3.0)
Prerequisite: Wi-Fi-enabled Miele
rangehood
If you do not have a home network, you
can establish a direct connection
between the cooktop and the
rangehood.
 Manually switch the rangehood off.
 Press and hold the  (B*) control.
 Press the  (1*) control at the same
time.
* Rangehoods with sensor controls.
2 will light up constantly, and 3 will flash
on and off.
The rangehood is ready for connection
during the next two minutes.
 Switch the cooktop on.
 Touch the 0 and 7 sensors at the
same time for 6 seconds.
The seconds can be seen counting
down in the timer display. When this
time has elapsed, a progress light will
appear during the connection attempt.
If the connection was successful, the
code : appears in the timer display.
If the connection could not be
established, the timer display will show
the code :. Repeat the steps above.
When successfully connected, 2 and 3
will light up constantly on the
rangehood.
 Quit connection mode on the
rangehood by pressing the run-on
control .
30
Con@ctivity has now been activated.
With a direct Wi-Fi connection, it is not
possible to connect the cooktop and
the rangehood to a home network. If
this is desired later, the direct Wi-Fi
connection between the cooktop and
the rangehood must first be reset (see
"Before using for the first time –
Con@ctivity - Resetting settings" and
in the operating and installation
instructions for the rangehood see
"Disconnecting the Wi-Fi").