Directed Electronics Matrix 1 Owner's Manual page 36

q q u u i i c c k k r r e e f f e e r r e e n n c c e e g g u u i i d d e e
To arm using your remote
You can activate, or arm, the system by pressing
➤
one second. When the system arms, you will hear a short siren sound, or chirp,
and the parking lights will flash once. If the vehicle's power door locks have been
connected to the system, the doors will lock.
To disarm using your remote
To disarm the system, press
➤
lights will flash twice. If power locks are connected to the system, the doors will
unlock. If the siren chirps either four or five times when disarming, see
Diagnostics section. This is called Tamper Alert.
Arming while driving
Press
➤
The system will chirp once and then once more to indicate that the ignition is on.
Disarming without a transmitter
Turn on the ignition. Press the Valet button the programmed number of times
➤
within 15 seconds. The system should now disarm. If it does not, you may have
waited too long. Turn the ignition off and on and try again.
To enter or exit Valet Mode
Turn ignition to RUN position, then turn to OFF position. Press and release
➤
the Valet button within 10 seconds. The status LED will light solid if you are
entering Valet Mode, and it will go out if you are exiting Valet Mode.
To activate Panic Mode
Press and hold
➤
To exit Panic Mode
Press on the transmitter.
➤
To activate remote controlled chirp muting
Press
➤
will be eliminated for that one operation only.
Location of Valet Button_______________________________
Number of Valet Button pulses for disarming_____________
© 2005 directed electronics—all rights reser ved
on your transmitter for two seconds while the vehicle is running.
down for one second.
briefly before arming or disarming, and the confirmation chirp(s)
on your transmitter for
. You will hear two chirps, and the parking
33