Arming Diagnostics; Disarming Diagnostics - Directed Electronics Matrix 1 Owner's Manual

during your absence. Refer to the System Status Chirps and
Table of Zones charts for diagnostic information.
➜

arming diagnostics

If the system is armed while an input is active (door open, sensor
triggering, etc.) the unit will chirp once when arming and then
one more time a few seconds later. This is called Bypass
Notification.
note: Bypass Notification will not occur when using
Remote Controlled Chirp Muting or if chirps have been
programmed OFF.
The security system will ignore the input that was active when
the system was armed, until the input goes away. Three seconds
later the system will monitor that input normally. For example,
if your vehicle has interior light exit delay, and you arm the
system before the interior light goes out, you may hear Bypass
Notification chirps. Once the light shuts off, however, the doors
are monitored normally.
➜

disarming diagnostics

Extra disarm chirps are the Tamper Alert. If four chirps are heard
when disarming, the system was triggered in your absence. If five
chirps are heard, a zone was triggered so many times that
False Alarm Control Technology (FACT) has bypassed that zone.
In either case, the LED status indicator will indicate which zone
14
© 2005 directed electronics—all rights reser ved