IPC1601&2602&5602&5603
User Guide
Figure 8-1 PTZ page
Step 2 Set the parameters according to Table 8-1.
Table 8-1 PTZ parameters
Parameter
Enable PTZ
PTZ Protocol
PTZ Address
Serial Port
Baud Rate
Data Bits
Stop Bits
Parity Verification
Step 3 Click OK.
Issue 12 (2014-06-12)
Description
Select this check box if the device
connects to an external PTZ.
NOTE
This check box is dimmed for a PTZ camera.
Protocol used by the external PTZ.
Address of the external PTZ.
The default value is COM1.
Baud rate used by the external PTZ. The
value ranges from 300 bit/s to 115200
bit/s. The default value is 4800 bit/s.
The value must match the setting used by
the external PTZ. It can be set to a value
ranging from 4 to 8. Generally, the value
is 8.
N/A
N/A
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8 External Device Configuration
Setting
[Default value]
Deselected
[Setting method]
Select a value from
the drop-down list
box.
[Default value]
NOTE
When configuring the
external PTZ
parameters, these
parameters must match
the settings on the
external PTZ.
60