Table of Contents
Advertisement
B B u u t t t t o o n n
The remote start function of your system is controlled by pressing
this button twice within 3 seconds.
and
Buttons
An optional auxiliary convenience or expansion function that you
have added to your system can be activated by pressing these but-
tons simultaneously.
The auxiliary output controls __________________________.
B B u u t t t t o o n n s s
+
When simultaneously pressed these buttons control the rear win-
dow defogger during remote starting.
U U s s i i n n g g Y Y o o u u r r S S y y s s t t e e m m
W W a a r r n n i i n n g g ! ! S S a a f f e e t t y y F F i i r r s s t t
The following safety warnings must be observed at all times:
■
Due to the complexity of this system, installation of this
product must only be performed by an authorized Directed
Electronics dealer.
■
When properly installed, this system can start the vehicle via
a command signal from the remote control transmitter.
Therefore, never operate the system in an enclosed area or
6 6
+
2005 Directed Electronics—all rights reserved
©
- Quick Links:
- Table of Contents
- Standard Configuration
- Arming
- Valet Mode
- Remote Start
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Automate AM6 and is the answer not in the manual?
Questions and answers
Door lock and unlock doesn’t work
The door lock and unlock may not be working on the Automate AM6 for several reasons:
1. Not Connected – The system requires proper connection to the vehicle's power door locks. If the wiring is incorrect or disconnected, the locks will not function.
2. Extra Parts Required – Some door lock systems need additional parts for compatibility. Check if your vehicle requires extra components.
3. Programming Issue – The system can be programmed to lock and unlock automatically. If it is not set up correctly, the feature may not work.
4. Failsafe® Starter Kill Activation – If this feature is engaged, it may prevent the system from operating normally. Disarm the system to check.
5. Faulty Module or Switch – If the factory door switch or module has failed, the automate system may have been installed as a workaround. If this module is also faulty, door locks may not work.
Check wiring, programming, and system components to diagnose the issue.
This answer is automatically generated