Table of Contents
Advertisement
T T o o e e n n t t e e r r o o r r e e x x i i t t V V a a l l e e t t M M o o d d e e : :
1. Turn the ignition on.
2. Turn the ignition off.
3. Press and release the Valet
The status LED will light steadily if you are entering Valet Mode
and will turn off if you are exiting Valet Mode.
P P a a n n i i c c M M o o d d e e
If you are threatened in or near your vehicle, you can attract
attention by triggering the system with your transmitter. Just
press
for 1.5 seconds to enter Panic Mode. In Panic Mode, the
horn will honk and the parking lights will flash for 30 seconds. To
stop Panic Mode at any time, press
transmitter.
N N O O T T E E : : In order for Panic Mode to be effective, the vehicle's horn (or
optional siren) as well as the vehicle's parking lights must be
connected.
2005 Directed Electronics—all rights reserved
©
button within 10 seconds.
DRW-35
, or
on the
1 1 1 1
- Quick Links:
- Table of Contents
- Standard Configuration
- Arming
- Valet Mode
- Remote Start
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Automate AM6 and is the answer not in the manual?
Questions and answers
Door lock and unlock doesn’t work
The door lock and unlock may not be working on the Automate AM6 for several reasons:
1. Not Connected – The system requires proper connection to the vehicle's power door locks. If the wiring is incorrect or disconnected, the locks will not function.
2. Extra Parts Required – Some door lock systems need additional parts for compatibility. Check if your vehicle requires extra components.
3. Programming Issue – The system can be programmed to lock and unlock automatically. If it is not set up correctly, the feature may not work.
4. Failsafe® Starter Kill Activation – If this feature is engaged, it may prevent the system from operating normally. Disarm the system to check.
5. Faulty Module or Switch – If the factory door switch or module has failed, the automate system may have been installed as a workaround. If this module is also faulty, door locks may not work.
Check wiring, programming, and system components to diagnose the issue.
This answer is automatically generated