Table of Contents
Advertisement
R R a a p p i i d d R R e e s s u u m m e e L L o o g g i i c c
This Directed Electronics system will store its current state to non-
volatile memory. If power is lost and then reconnected the system
will recall the stored state from memory. This means if the unit is
in Valet Mode and the battery is disconnected for any reason, such
as servicing the car, when the battery is reconnected the unit will
still be in Valet Mode. This applies to all states of the system
including arm, disarm, and Valet Mode.
P P r r o o g g r r a a m m m m i i n n g g O O p p t t i i o o n n s s
Programming options control your system's normal, operational
set-up. Most options do not require additional parts, but some may
require additional installation labor. This system's programming
options are listed below, with the factory default settings in b b o o l l d d :
■
1 1 2 2 , , 24, or 60 minute run time. your system can be pro-
grammed to allow the vehicle to run for 12, 24, or 60 min-
utes when remote started.
■
3, 6, 9, or 1 1 2 2 minute timer mode run time. Your system can
be programmed to allow the vehicle to run for 3, 6, 9, or 12
minutes when remote started in timer mode. Can be set up to
16 minutes by your installer.
1 1 8 8
2005 Directed Electronics—all rights reserved
©
- Quick Links:
- Table of Contents
- Standard Configuration
- Arming
- Valet Mode
- Remote Start
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Automate AM6 and is the answer not in the manual?
Questions and answers
Door lock and unlock doesn’t work
The door lock and unlock may not be working on the Automate AM6 for several reasons:
1. Not Connected – The system requires proper connection to the vehicle's power door locks. If the wiring is incorrect or disconnected, the locks will not function.
2. Extra Parts Required – Some door lock systems need additional parts for compatibility. Check if your vehicle requires extra components.
3. Programming Issue – The system can be programmed to lock and unlock automatically. If it is not set up correctly, the feature may not work.
4. Failsafe® Starter Kill Activation – If this feature is engaged, it may prevent the system from operating normally. Disarm the system to check.
5. Faulty Module or Switch – If the factory door switch or module has failed, the automate system may have been installed as a workaround. If this module is also faulty, door locks may not work.
Check wiring, programming, and system components to diagnose the issue.
This answer is automatically generated