Table of Contents
Advertisement
T T r r a a n n s s m m i i t t t t e e r r F F u u n n c c t t i i o o n n s s
The receiver uses a computer-based learn routine to learn the
transmitter buttons. This makes it possible to assign any specific
transmitter button, or combination of buttons, to any receiver
function. The transmitter initially comes programmed with the
Standard Configuration, but may also be customized by an autho-
rized dealer. The transmitter buttons indicated in all of the
instructions in this manual correspond to a Standard Configuration
transmitter.
S S t t a a n n d d a a r r d d C C o o n n f f i i g g u u r r a a t t i i o o n n
B B u u t t t t o o n n
The arming and panic functions are controlled by pressing
on
the transmitter for one second.
B B u u t t t t o o n n
The disarm function is controlled by pressing
on the trans-
mitter for one second.
B B u u t t t t o o n n
Silent Mode
™
and an optional auxiliary function are controlled
by pressing
. Silent Mode works by pressing
for less
than one second. An optional auxiliary function, such as
trunk release, is controlled by pressing and holding
for
1.5 seconds.
5 5
2005 Directed Electronics—all rights reserved
©
- Quick Links:
- Table of Contents
- Standard Configuration
- Arming
- Valet Mode
- Remote Start
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Automate AM6 and is the answer not in the manual?
Questions and answers
Door lock and unlock doesn’t work
The door lock and unlock may not be working on the Automate AM6 for several reasons:
1. Not Connected – The system requires proper connection to the vehicle's power door locks. If the wiring is incorrect or disconnected, the locks will not function.
2. Extra Parts Required – Some door lock systems need additional parts for compatibility. Check if your vehicle requires extra components.
3. Programming Issue – The system can be programmed to lock and unlock automatically. If it is not set up correctly, the feature may not work.
4. Failsafe® Starter Kill Activation – If this feature is engaged, it may prevent the system from operating normally. Disarm the system to check.
5. Faulty Module or Switch – If the factory door switch or module has failed, the automate system may have been installed as a workaround. If this module is also faulty, door locks may not work.
Check wiring, programming, and system components to diagnose the issue.
This answer is automatically generated