Table of Contents
Advertisement
G G l l o o s s s s a a r r y y o o f f T T e e r r m m s s
C C o o n n t t r r o o l l U U n n i i t t : The "brain" of your system. Usually hidden under-
neath the dash area of the vehicle. It houses the microprocessor
which monitors your vehicle and controls all system functions.
F F a a i i l l s s a a f f e e
® ®
S S t t a a r r t t e e r r K K i i l l l l : : An automatic switch controlled by your sys-
tem which prevents the vehicle's starter from cranking whenever
the system is armed. The vehicle is never prevented from cranking
when the system is disarmed, in Valet Mode, or if the starter kill
switch itself fails. Your system has feature-ready circuitry for the
starter kill, however installation may require additional labor.
L L E E D D : : A red light mounted at a discretionary location inside the
vehicle. It is used to indicate the status of your system.
T T r r a a n n s s m m i i t t t t e e r r : : A hand-held, remote control which operates the vari-
ous functions of your system.
V V a a l l e e t t B B u u t t t t o o n n : : A small push button mounted at a discretionary
location inside the vehicle. It is used to override the Failsafe
®
Starter Kill when a transmitter is lost or damaged, or to enter or
exit Valet Mode.
2 2 0 0
2005 Directed Electronics—all rights reserved
©
- Quick Links:
- Table of Contents
- Standard Configuration
- Arming
- Valet Mode
- Remote Start
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Automate AM6 and is the answer not in the manual?
Questions and answers
Door lock and unlock doesn’t work
The door lock and unlock may not be working on the Automate AM6 for several reasons:
1. Not Connected – The system requires proper connection to the vehicle's power door locks. If the wiring is incorrect or disconnected, the locks will not function.
2. Extra Parts Required – Some door lock systems need additional parts for compatibility. Check if your vehicle requires extra components.
3. Programming Issue – The system can be programmed to lock and unlock automatically. If it is not set up correctly, the feature may not work.
4. Failsafe® Starter Kill Activation – If this feature is engaged, it may prevent the system from operating normally. Disarm the system to check.
5. Faulty Module or Switch – If the factory door switch or module has failed, the automate system may have been installed as a workaround. If this module is also faulty, door locks may not work.
Check wiring, programming, and system components to diagnose the issue.
This answer is automatically generated