Table of Contents
Advertisement
R R e e m m o o t t e e S S t t a a r r t t
This feature allows you to remotely start and run your vehicle for
a programmable period of time. This makes it possible to warm up
the engine, as well as adjust the interior temperature of the vehi-
cle with the climate control system. If interior heating or cooling
is desired, the climate controls must be preset, and the fan blower
must be set to the desired level prior to remote starting the
vehicle.
I I M M P P O O R R T T A A N N T T ! ! (1) Never remotely start the vehicle with the vehicle
in gear, and (2) Never remotely start the vehicle with the key in the
ignition.
T T o o r r e e m m o o t t e e s s t t a a r r t t t t h h e e v v e e h h i i c c l l e e : :
1.
Press the
mitter.
2.
The parking lights will flash to confirm that the vehicle will
attempt to start.
3.
Release the
(In gasoline vehicles, the engine will start 4 seconds after
the parking lights flash. In diesel vehicles, the engine will
start when the WAIT-TO-START indicator on the vehicle's dash
goes out or the timer has expired.)
4.
Once the vehicle has started, it will run for the pre-program-
med period of time (12, 24, or 60 minutes) or until a shut-
down input is triggered.
1 1 2 2
button twice within 3 seconds on the trans-
button as soon as the parking lights flash.
2005 Directed Electronics—all rights reserved
©
- Quick Links:
- Table of Contents
- Standard Configuration
- Arming
- Valet Mode
- Remote Start
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Automate AM6 and is the answer not in the manual?
Questions and answers
Door lock and unlock doesn’t work
The door lock and unlock may not be working on the Automate AM6 for several reasons:
1. Not Connected – The system requires proper connection to the vehicle's power door locks. If the wiring is incorrect or disconnected, the locks will not function.
2. Extra Parts Required – Some door lock systems need additional parts for compatibility. Check if your vehicle requires extra components.
3. Programming Issue – The system can be programmed to lock and unlock automatically. If it is not set up correctly, the feature may not work.
4. Failsafe® Starter Kill Activation – If this feature is engaged, it may prevent the system from operating normally. Disarm the system to check.
5. Faulty Module or Switch – If the factory door switch or module has failed, the automate system may have been installed as a workaround. If this module is also faulty, door locks may not work.
Check wiring, programming, and system components to diagnose the issue.
This answer is automatically generated