Introduction - DCS RGT-364GD Installation Manual

INTRODUCTION

The DCS RGT series ranges are designed with a large number of features available in a multitude of different
TM
combinations. Patented Dual Flow Burners allow for consistently lower simmer temperatures and have a high
output of 17,500 Btu/hr, with two burners at 12,500 Btu/hr. Also available on the ranges are an 18,000 Btu/hr
griddle and/or grill.
The large capacity gas convection ovens, 30,00 Btu/hr, of the RGT series are equipped with an in-oven gas
infrared broiler, 19,000 Btu/hr. The smaller gas oven, 18,000 Btu/hr, found on the 48" RGT series is ideal for
baking smaller dishes. All range models require the installation of one of the two offered Backguards if installed
with less than 12" to combustible material. See pages 8 and 17.
IMPORTANT INSTALLATION INFORMATION
The RGT series ranges are tested in accordance with ANSI Z21.1 Standard for Household Cooking Gas Appliances.
These ranges must be installed in conjunction with a suitable overhead vent hood (see ventilation requirements).
Due to the professional high heat capacity of this unit, particular attention should be paid to the hood and duct
work installation to ensure it meets local building codes. To eliminate risk of burns or fire by reaching over
heated surface units, cabinet storage located above the surface units should be avoided.
Check local building codes for the proper method of range installation. Local codes vary. Installation, electrical
connections, and grounding must comply with all applicable codes. In the absence of local codes, the range
should be installed accordance with the National Fuel Gas Code ANSI Z223-1 and National Electrical Code
ANSI/NFPA 70. Be sure that the unit being installed is set up for the kind of gas being used. The gas ranges are
shipped from the factory set and adjusted for natural gas or LP (propane), depending on the specific model
ordered. Verify that the range is compatible with gas supply at the installation site before proceeding
further. Return range to dealer if unit is not set for site gas supply.
3