Remote Control; Transponder (Rfid Tag) - Gemini 953NH User's And Installer's Manual

10.0 - REPLACING

10.1 - REMOTE CONTROL

When the remote control batteries are too weak (see par. 2.2), replace them as
follows:
!
Separate the remote shells taking care not to damage the internal circuit.
!
Remove the discharged batteries.
!
Insert the new batteries taking care not to invert polarity.
!
Close the remote shells.
WARNING
!
Use only CR1616 batteries.
Inserting the batteries the wrong way and/or using different type batteries
can damage the remote control or cause the batteries to explode.
Discard used batteries properly in special dedicated containers.
PAGE15
BATTERIES
BATTERIES
10.2 - TRANSPONDER
Proceed as follows to replace the battery:
1. Separate the plastic covers and remove the circuit with care.
1
3. Reassemble the
covers, turn ON
the TAG and make
sure it works.
! ATTENTION
Use only CR2032 type batteries.
Inserting the battery the wrong way and/or using different type batteries
can damage the remote control or cause the batteries to explode.
Discard used batteries properly in special dedicated containers.
+
2
2. Slide out the dead battery and
insert a new one. Pay attention
not to invert polarity.
3
PAGE 16