Table of Contents
Advertisement
4.4 - PASSIVE ARMING
Passive arming is factory enabled (see par. 3.1). Do not modify.
4.5 - ANTI-HIJACK FEATURE
To activate the anti-hijack feature while the engine is running, either:
!
Walk away from your vehicle, it will activate automatically when the TAG is
no longer detected.
!
Press remote control button "1".
!
Press remote control button "2".
!
Press the anti-hijack button (if available).
The LED will turn ON steady and the turn indicators will flash twice to confirm
the anti-hijack feature has been activated.
20 sec. after the anti-hijack feature has been activated, the siren will sound for
approx. 1 min. while the turn indicators will flash until the anti-hijack is
deactivated.
The system will kill the engine 2 sec. after the siren is triggered.
To exit the anti-hijack mode:
!
Press the TAG button.
!
Press the anti-hijack button for 2 sec. (if available).
!
Enter the PIN code.
To exit the anti-hijack mode via PIN code proceed as follows:
!
Wait for the siren to stop wailing.
!
If ignition key is in the ON position, turn it OFF.
!
If key is in the OFF position, cycle it ON and OFF.
!
After 4 sec. there will be a
sequence of 9 LED flashes.
!
From this point on, proceed as indicated in par. 7.0 and 8.0.
!
Disarming via PIN code will be confirmed by 3 Beep and 3 flashes of the
turn indicators.
The anti-hijack mode has a memory feature.
I
f the power supply is disconnected and subsequently
reconnected an alarm will be triggered because
considered a theft attempt.
PAGE 9
If the pre-alarm feature is enabled, the siren, during an alarm condition , will
start sounding for approx. 2.5 sec. for the first 3 cycles, then from the 4th cycle
on, it will sound for 30 sec.
Alarm cycles will be reset every time the alarm is disarmed or whenever the
panic alarm is activated.
When the system is armed and then accidentally disarmed, the system will
automatically rearm 35 sec. after it has been unintentionally disarmed.
5.0 - SLEEP MODE - ENERGY SAVER FEATURE
In order to preserve battery life, t
mode
72h after it has been armed. All protection features are operative during
sleep mode except the status LED.
The remote control is inoperative, normal operation is restored when ignition
is switched ON.
If only the TAG is used, press the TAG button immediately after starting the
engine.
When the engine is switched ON, there is a 5 sec. delay to allow disarming
without triggering the siren.
6.0 - HAZARD WARNING FLASHERS
To make the turn indicators flash as Hazard warning lights, proceed as
follows:
With the system disarmed, turn ignition key in "ON"; the LED will light up for
approx. 1 sec.
!
While the LED is ON, press remote control button "1".
!
Turn ignition key "OFF"; the turn indicators will start flashing.
!
To disable the flashers, turn ignition key "ON" (and eventually "OFF") or
arm the system.
it will be
4.6 - PRE-ALARM MODE
4.7 - SELF-REARMING
he system automatically reverts to sleep
PAGE 10
Advertisement
Table of Contents
