Start Job "Js" Nn 00H 00H <Job Name> M1; End Job "Je" 01H 00H 00H - Epson WF-M1560 Programming Manual

6.1.6 Start job "JS" nn 00H 00H <job name> m1

6.1.7 End job "JE" 01H 00H 00H

[Format]
"JS" nL nH 00H <job name> m1
"JE" 01H 00H 00H
nL = (length of <job name>) + 2
nH = 00H
[Parameters]
[Function]
Construct a print job. Then turn page and line position reply on/off, and set the position reply repeat
rate if the position reply is enabled. If the host uses the cancel job command or it needs the page and
line position reply, it must send print data as a print job.
The print job is started with the "JS" command and terminated with the "JE" command. After
starting a job with the "JS", if the "JS" is sent again without the "JE", the previous print job will be
terminated with the second "JS".
After power-on initialization, the print job is not defined, and position reply is disabled.
This command will be ignored and skipped if the product does not support this command.
This command is available only in Remote.
Revision: 1
The parameter "m1" is one byte binary data that fixed to zero.
2012/10/15
Page: 61