Table of Contents
Advertisement
212-LC and HTS PAL
Figure 2 shows a possible layout for the LC/MS with 212-LC pumps and CTC HTS PAL
Autosampler.
Figure 2 Suggested Layout with 212-LC and HTS PAL
Table 3 and Table 4 provide information about the modules in Figure 2.
Table 3 Bench Width with the HTS PAL
Bench
Width
cm
in.
Table 4 Bench Load with the HTS PAL
Bench
Load
The system requires a clean, flat bench. The bench must be strong enough to support the
weight of the modules. The area under the bench must be large enough for the foreline pump. If
the bench is against a wall, drill a hole large enough for the vacuum tubing of your pump
through the rear of the bench. The area under the bench must be large enough for the height of
the foreline pump, see Table 8. If the bench is higher than 92 cm (36 in.) place a vibration-
isolation bench under the foreline pump. The vibration–isolation bench must be capable of
supporting the foreline pump.
Plan to put the monitor and keyboard on the same bench as the LC/MS. If the plan is to use a
separate bench, position them within 3 m (10 ft) of the rear of the LC/MS. The CPU can go on
or under the bench.
9300025700: Rev. A
212-LC
26
10.5
212-LC
kg
14.5
lb
32
MS with HTS PAL
53.5
21
MS with HTS PAL
71
162
5 of 14
Monitor and
CPU
Keyboard
18.7
51
7.5
20
CPU
Monitor and
Keyboard
11.5
5.5
23.5
11.5
Pre-installation Instructions
Total
150 cm
59 in.
Total
102.5 kg
231 lb
Advertisement
Table of Contents
