Comtrend Corporation NexusLink 3120 User Manual page 92

Field
Traffic Class Name
Rule Order
Rule Status
Classification Criteria
Ingress Interface
Ether Type
Source MAC Address
Source MAC Mask
Destination MAC
Address
Destination MAC Mask
Classification Results
Specify Egress
Interface
Specify Egress Queue
Mark Differentiated
Service Code Point
Mark 802.1p Priority
Set Rate Limit
Description
Enter a name for the traffic class.
Last is the only option.
Disable or enable the rule.
Select an interface: (i.e. LAN, WAN, local, ETH1, ETH2,
ETH3, wl0)
Set the Ethernet type (e.g. IP, ARP, IPv6).
A packet belongs to SET-1, if a binary-AND of its source
MAC address with the Source MAC Mask is equal to the
binary-AND of the Source MAC Mask and this field.
This is the mask used to decide how many bits are checked
in Source MAC Address.
A packet belongs to SET-1 then the result that the
Destination MAC Address of its header binary-AND to the
Destination MAC Mask must equal to the result that this
field binary-AND to the Destination MAC Mask.
This is the mask used to decide how many bits are checked
in the Destination MAC Address.
Choose the egress interface from the available list.
Choose the egress queue from the list of available for the
specified egress interface.
The selected Code Point gives the corresponding priority to
packets that satisfy the rule.
Select between 0-7.
- Class non-vlan packets egress to a non-vlan interface will
be tagged with VID 0 and the class rule p-bits.
- Class vlan packets egress to a non-vlan interface will
have the packet p-bits re-marked by the class rule p-bits.
No additional vlan tag is added.
- Class non-vlan packets egress to a vlan interface will be
tagged with the interface VID and the class rule p-bits.
- Class vlan packets egress to a vlan interface will be
additionally tagged with the packet VID, and the class rule
p-bits.
The data transmission rate limit in kbps.
91