Comtrend Corporation NexusLink 3120 User Manual page 181

NOTE: The WAN services shown here are those supported by the layer 2
interface you selected in the previous step. If you wish to change your
selection click the Back button and select a different layer 2 interface.
STEP 4: For VLAN Mux Connections only, you must enter Priority & VLAN ID tags.
Select a TPID if VLAN tag Q-in-Q is used.
STEP 5: You will now follow the instructions specific to the WAN service type you
wish to establish. This list should help you locate the correct procedure:
(1) For F2.1 PPP over ETHERNET (PPPoE) – IPv4
(2) For F2.2 IP over ETHERNET (IPoE) – IPv4
(3) For F2.3 Bridging – IPv4
(4) For F2.4 PPP over ATM (PPPoA) – IPv4
(5) For F2.5 IP over ATM (IPoA) – IPv4
(6) For F2.6 PPP over ETHERNET (PPPoE) – IPv6
(7) For F2.7 IP over ETHERNET (IPoE) – IPv6
(8) Bridging – IPv6 (Not Supported)
(9) For F2.8 PPP over ATM (PPPoA) – IPv6
(10) IPoA – IPv6 (Not Supported)
The subsections that follow continue the WAN service setup procedure.
180