Comtrend Corporation NexusLink 3120 User Manual page 11

ETH WAN PORT
This port has the same features as the LAN ports described below with additional
Ethernet WAN functionality.
Ethernet (LAN) Ports
Use 1000-BASE-T RJ-45 cables to connect up to four network devices to a Gigabit
LAN, or 10/100BASE-T RJ-45 cables for standard network usage. These ports are
auto-sensing MDI/X; so either straight-through or crossover cable can be used.
USB Host Port (Type A)
A USB host port supports compatible printers (See Appendix E for setup instructions)
or storage devices. If a storage device is connected to the USB host port, it can be
used to stream the DLNA service. Support for other devices may be added in future
firmware upgrades.
DSL Port
Connect to an ADSL2/2+ or VDSL with this RJ11 Port. This device contains a micro
filter which removes the analog phone signal. If you wish, you can connect a
regular telephone to the same line by using a POTS splitter.
FRONT PANEL
2.4G WiFi On/Off & WPS Button
Press and release the WiFi-WPS button to activate WPS for the 2.4GHz WiFi
interface (make sure the WPS is enabled in Wireless->2.4GHz->Security page).
Press and hold WiFi-WPS button more than 10 seconds to enable/disable 2.4GHz
WiFi.
5G WiFi On/Off & WPS Button
Press and release the WiFi-WPS button to activate WPS for the 5GHz WiFi interface
(make sure the WPS is enabled in Wireless->5GHz->Security page).
Press and hold WiFi-WPS button more than 10 seconds to enable/disable 5GHz WiFi.
10