BT Diverse 2000 User Manual page 36

To set your handset for manual base
selection (with an automatic search
default)
This setting tells your handset to search
for a specific base signal for 30 seconds.
If the signal cannot be found, the
handset reverts to automatic selection of
the base with the best signal. This setting
is recommended where there is an overlap
between two or three base stations.
The handset must be switched ON.
STO
• Press the
• Press the
the numbers of the base stations at
which the handset is registered.
• Press the number of the base (from
to
1
make calls.
• Press the same number again. This
tells the handset to revert to automatic
search if the chosen base is unavailable.
• Press
If you do not wish to allow the handset
to revert to automatic signal selection
press the base station number just once.
This will mean that the handset can
only operate through the base you select.
If you move out of range from one base
station and into the range of another
during a call, you will lose your
connection.
If your handset is taken out of range,
switch it off, move back into base station
range, and then switch on again. This
will speed up re-registration to the base
signal.
34
1-4
INT
STO
INT
) through which you wish to
4
to confirm.
STO
button.
button. Display shows