General Procedure - Siemens RUGGEDCOM WIN7014 Installation Manual

Table of Contents

Advertisement

Chapter 2
Installing the Base Station
IMPORTANT!
Install equipment in accordance with the electrical code relevant to the country of installation, such as:
• the National Electrical Code (NEC), ANSI/NFPA 70
• the Canadian Electrical Code (CEC), Part 1, CSA C22.1
• the National Electrical Safety Code IEEE C2 (when applicable)
Unless marked or otherwise identified, the Standard for the Protection of Electronic Computer/Data
Processing Equipment, ANSI/NFPA 75, also applies.
IMPORTANT!
Outdoor exposed communication lines longer than 40 m (140 ft) must be considered as TNV-1 circuits.
The installer must make sure the power supply and network ports are designed for full compliance with
the standards for TNV-1 telecommunication networks.
IMPORTANT!
The warranty is void if the base station is assembled without waterproof sealing or if the sealing is
removed from the connections.
CONTENTS
Section 2.1, "General Procedure"
Section 2.2, "Unpacking the Base Station"
Section 2.3, "Site Preparation and Precautions"
Section 2.4, "Installing the Base Station in Hazardous Locations"
Section 2.5, "Mounting the Base Station"
Section 2.6, "Installing Antennas"
Section 2.7, "Grounding the Base Station"
Section 2.8, "Connecting Power and Data"
Section 2.9, "Weatherproofing the Base Station"
Section 2.1

General Procedure

The general procedure for installing the base station is as follows:
IMPORTANT!
The user is responsible for the operating environment of the device, including maintaining the integrity
of all protective conductor connections and checking equipment ratings. Make sure to review all
operating and installation instructions before commissioning or performing maintenance on the
device.
IMPORTANT!
Before installing the base station in a Class I, Division 2 hazardous location, make sure to review
the conditions for safe use. For more information, refer to
Hazardous
8
Locations".
Section 2.4, "Installing the Base Station in
RUGGEDCOM WIN7014
Installation Guide
General Procedure

Advertisement

Table of Contents
loading

Table of Contents