Table of Contents
Advertisement
Chapter 2
Installing the Base Station
2.
Liberally apply an anti-corrosion spray to all galvanized steel components, including mounting brackets, nuts,
washers and screws.
3.
Select a mounting location on the pole.
4.
Lift the base station and mounting bracket assembly and align it with the selected mounting location on the
pole.
Figure 5: Securing the Base Station and Mounting Bracket Assembly to a Pole
1. Nut 2. Spring Washer 3. Flat Washer 4. Screw 5. Fastening Bracket
5.
Secure the fastening brackets on the opposite side of the pole to the mounting bracket using the supplied
nuts, spring washers, flat washers, and 7.9 × 152 mm (5/16 × 6 in) screws.
6.
Liberally apply an anti-corrosion spray to all exposed screw threads.
Section 2.5.3
Assembling the Base Station and Mounting Bracket
To assemble the base station and mounting bracket together, do the following:
1.
Make sure the mounting bracket is standing on its base.
2.
If assembled, remove the top plate from the mounting bracket.
3.
Lift the base station by its eye bolts and fit it into the mounting bracket.
14
3
5
3
1
2
4
2
Assembling the Base Station and Mounting Bracket
RUGGEDCOM WIN7014
Installation Guide
1
Advertisement
Table of Contents
