Operation - Makita CG100D Instruction Manual

OPERATION

Using cartridge
Preparing cartridge for use
1. Cut the tip of the cartridge nozzle so that the suit-
able amount of caulking material is fed.
1
► 1 . Nozzle
2. Make a hole on the protective film with the tip of
the nozzle.
1
► 1 . Nozzle
3. Attach the nozzle to the cartridge.
NOTICE:
Be sure to check the cartridge for
damage before installation. Using the damaged
cartridge may cause malfunction.
NOTICE:
When reusing the partially used car-
tridge, be sure to remove the solid caulking mate-
rial before the installation.
Installing cartridge to 300 ml size
holder
NOTICE:
Make sure that piston A is attached
to the rod. Do not use other type of piston for
cartridge.
1.
Pull the rod handle backward slowly until it stops.
► 1 . Rod handle
2. Insert the cartridge into the holder as shown in the
figure.
3. Push the rod gently until the piston touches the
bottom of cartridge.
To remove the cartridge, follow the installation proce-
dure in reverse.
Installing cartridge to 600 ml or 800
ml size holder
NOTICE:
Make sure that piston A (for 600 ml
size holder) or piston D (for 800 ml size holder) is
attached to the rod. Do not use other type of pis-
ton for cartridge.
1.
Remove the holder cap from the holder, and then
pull the rod handle backward slowly until it stops.
1
► 1 . Holder cap 2. Rod handle
2. Insert the cartridge into the holder.
9 ENGLISH
1
2