Pedal Assist; Speedometer; Walk Mode - Jetson JOURNEY Manual

If the LCD Display does not turn on, check that the battery is charged and the
LCD Display is fully connected. If you are still having issues, please contact
Jetson support.

PEDAL ASSIST

The Pedal Assist mode was designed to make riding an e-bike mimic the
natural motion you are used to feeling when riding a bicycle. As you pedal
your bike, a sensor is activated, which in turn generates power from the
motor. The power is activated only when you pedal – and the amount of
power is determined by the pedal assist level that you choose.
The Pedal Assist mode provides power and propels the bike as you pedal.
A low Pedal Assist level (1-3) will require effort from you to pedal, a medium
Pedal Assist level (4-6) will require some effort from you to pedal, and a high
Pedal Assist level (7-9) will require minimal effort from you.
To increase the Pedal Assist, press the Up Button. To decrease the Pedal
Assist, press the Down Button. Always start off slowly and gradually increase
your level. Make sure your speed is appropriate to riding conditions (weather,
road surface, traffic/pedestrians, etc.). Level 0 will not use Pedal Assist.

SPEEDOMETER

Once the LCD Display is turned on, it will display the Speedometer. Press
the Power Button (M) to cycle through different functions such as the
Trip Distance, the Odometer, the Ride Time, the Average Speed, and the
Maximum Speed. It will return to your current speed after a few moments of
inactivity.

WALK MODE

The Walk Mode will power the bike at about 3.7 mph to allow you to walk
alongside the bike without needing to push it. Stand at the side of the bike
with both hands on the handlebars and make sure the way in front of you is
clear. Press and hold the Down Button to enable Walk Mode. A "P" will appear
in the upper right-hand corner of the LCD Display. Release the Down Button
to exit Walk Mode.
15