Page 1
50psi (3.5Bar) Max Air Pressure: 87psi (6Bar) Av. Air Consumption: 85-226L/min (3-8cfm) Nozzle Size: ø1.5mm Spray Width: 40-70mm Flow Rate: 150-200ml/min Feed Type: Suction Paint Pot Size: 650ml Air Inlet: 1/4” BSP Paint Pot Weight (tool only): 0.71kg ozito.com.au ASG-LPR...
Page 2
KNOW YOUR PRODUCT SETUP & PREPARATION LOW PRESSURE SPRAY GUN 1. ASSEMBLY 1 Nozzle 6 Air Regulator Valve 2 Nozzle Collar 7 Air Inlet WARNING! ENSURE THE TOOL IS DISCONNECTED FROM 3 Suction Tube Locking Nut 8 Fluid Adjustment Dial THE AIR SUPPLY BEFORE PERFORMING ANY OF THE FOLLOWING OPERATIONS.
Page 3
OPERATION 3. ADJUSTING THE SPRAY GUN 2. PREPARATION Variable Trigger NOTE: FOR BEST RESULTS, SURFACE PREPARATION AND PAINT THINNING ARE THE TWO MOST IMPORTANT AREAS. ENSURE 1 Squeeze the variable 2 Release the variable ALL SURFACES ARE FREE OF DUST, DIRT AND GREASE. trigger to start spraying.
Page 4
After each use it is essential that the spray gun is cleaned thoroughly. Failure to do so will likely cause blockages which will prevent the tool from working. FAILURE TO CLEAN THE TOOL WILL VOID THE WARRANTY. Ensure the suction tube locking nut is tightened after adjusting. ASG-LPR...
Page 5
Spare parts can be ordered from the Special Orders Desk at your local Bunnings Warehouse. For further information, or any parts not listed here, visit www.ozito.com.au or contact Ozito Customer Service: Take note of the 4 holes on the Australia 1800 069 486 nozzle, if blocked clean carefully using a small needle.
Page 6
SPARE PARTS How To Order Available spare parts can be ordered through the Special Orders Desk at any Bunnings Warehouse. If you have any further questions, please contact Ozito Customer Service on: Australia: 1800 069 486 New Zealand: 0508 069 486...
Page 7
GENERAL AIR TOOL SAFETY WARNINGS WARNING! WARNING! Read all safety warnings and all instructions. Failure to follow the warnings In the event that an air line is cut or broken, the air supply must be turned off at the and instructions may result in electric shock, fire and/or serious injury. compressor.
Page 8
• Failure to perform maintenance as set out within the instruction manual. • If the tool is disassembled or tampered with in any way. • Professional, industrial or high frequency use. OZITO Australia/New Zealand (Head Office) 1-23 Letcon Drive, Bangholme, Victoria, Australia 3175. 0414...
Need help?
Do you have a question about the ASG-LPR and is the answer not in the manual?
Questions and answers