Installing The Input And Output Board; Power Connector Port; Removing The Power Connector - Dell Vostro 15 3578 Owner's Manual

Installing the Input and Output board

1 Place the I/O board on the computer.
2 Connect the input/output (I/O board) cable and tighten the 1 (M2x3) screw.
3 Install the:
a Hard drive assembly
b Base cover
c Keyboard
d Optical drive
e Battery
4 Follow the procedure in

Power connector port

Removing the power connector

1 Follow the procedure in
2 Remove the:
a Battery
b Optical drive
c Keyboard
d Base cover
e Hard drive assembly
f WLAN card
g Memory module
h Heat sink
i System fan
j Coin cell battery
k System board
3 To remove the power connector:
a Lift the cable from the slot [1].
b Remove the 1 (M2x3) screw that secures the power connector to the computer [2].
c Lift the power connector [3].
After working inside your computer.
Before working inside your computer.
Removing and installing components 37