Installation - D-Link DCS-900 Install Manual

Installation

Attach the Swivel Stand
Locate the stand mount on the
bottom panel of the DCS-900
and screw on the swivel stand
to the base of the DCS-900.
Connect the Ethernet Cable
Connect the included Ethernet
cable to the network cable
connector located on the back
panel of the DCS-900 and
attach it to the network. Network
connectivity is confirmed when
the green LED Indicator on the
DCS-900, located below the
Power LED, is illuminated.
Attach the Power Supply
Attach the power supply to
the DC power input connector
located on the rear panel of the
DCS-900 and connect it to your
local power supply.
Note: Power source is confirmed
when the red LED Power Indicator
located to the right of the lens on
the DCS-900 is illuminated.
5 D-Link DCS-900 Quick Install Guide