Installation; Mounting The Camera - D-Link DCS-4701E User Manual

Section 2: Installation
It is highly recommended that you configure and test your camera before mounting it. Refer to "Software Installation" on page 14 for more
information.
Step 1
Place the mounting sticker where you want to position the camera.
Use a 6 mm drill bit to make the required holes approximately 25 mm deep, then insert the
wall anchors into the holes.
Step 2
If you are running the camera cables through the wall, drill a hole in the center and pull
the cables through the hole.
Step 3
Use the screws provided to mount the camera to the wall.
If you are running the camera cables out the side of the camera, guide the camera cables
through the cable channel on the base.
D-Link DCS-4701E User Manual

Installation

Mounting the Camera

9