Hardware Installation - D-Link DCS-5220 Quick Install Manual

Hardware Installation

Hardware Installation
Connect an Ethernet cable to the
Ethernet connector located on the
Internet Camera's back panel and
attach it to the network.
Note: It is required that an Ethernet
cable is used during initial setup.
Once your wireless configuration is
set, you may disconnect the Ethernet
cable and begin communicating
wirelessly with your DCS-5220.
Attach the external power supply
to the DC power input connector
located on the Internet Camera's
back panel (labeled DC 12V) and
connect it to an AC power outlet.
5 D-Link DCS-50 Quick Install Guide