Axis Q1942-E User Manual page 55

AXIS Q1942-E PT Mount Thermal Network Camera
Technical specifications
Technical specifications
You can find the latest version of the technical specifications at www.axis.com
LED Indicators
Status LED
Unlit
Green
Amber
Amber/Red
Red
SD card slot
NOTICE NO NO TICE TICE
• Risk of damage to SD card. Do not use sharp tools, metal objects or excessive force when inserting or removing the
SD card. Use your fingers to insert and remove the card.
• Risk of data loss and corrupted recordings. Do not remove the SD card while the product is running. Disconnect power or
unmount the SD card from the Axis product's webpages before removal.
This product supports microSD/microSDHC/microSDXC cards (not included).
For SD card recommendations, see www.axis.com
Buttons
Control Button
For location of the control button, see Hardware overview on page 7 .
The control button is used for:
• Resetting the product to factory default settings. See page 51.
• Connecting to an AXIS Video Hosting System service. See page 43. To connect, press and hold the button for about 3
seconds until the Status LED flashes green.
• Connecting to AXIS Internet Dynamic DNS Service. See page 43. To connect, press and hold the button for about 3 seconds.
Connectors
Network connector
RJ45 Ethernet connector with Power over Ethernet (PoE).
NOTICE TICE
NO NO TICE
The product shall be connected using a shielded network cable (STP). All cables connecting the product to the network shall
be intended for their specific use. Make sure that the network devices are installed in accordance with the manufacturer's
instructions. For information about regulatory requirements, see Electromagnetic compatibility (EMC) on page 2 .
Indication
Connection and normal operation.
Connection and normal operation.
Steady during startup. Flashes during firmware upgrade or reset to factory default.
Flashes amber/red if network connection is unavailable or lost.
Firmware upgrade failure.
55