JVC KW-AVX810J Service Manual page 15

3.1.2 Removing the Heat sink (See Fig.6)
(1) Remove the two screws D and four screws E attaching the
Heat sink.
3.1.3 Removing the Rear bracket (See Fig.7 to 9)
(1) Remove the three screws F attaching the Rear heat sink.
(See Fig.7)
(2) Remove the nine screws G and one screw H attaching the
rear bracket. (See Fig.8)
(3) Disconnect the connector wire from Car cable connected to
connector CN601 of the Sub board. (See Fig.9)
(4) Disconnect he connector wire from Fan connected to con-
nector CN604 of the Sub board. (See Fig.9)
F
G H
Fig.7
G
G
Fig.8
E
E D D E
Fig.6
CN601
Fig.9
E
CN604
(No.MA403<Rev.001>)1-15