Supermicro X11DPG-QT User Manual page 58

Super X11DPG-QT User's Manual
NC-SI Header for IPMI Support
A Network-Controller Sideband Interface (NC-SI) header is located at JNCSI1 on the
motherboard. Connect an appropriate cable from this header to an add-on card to provide the
out-of-band (sideband) connection between the onboard Baseboard Management Controller
(BMC) and a Network Interface Controller (NIC) for remote management. For the network
sideband interface to work properly, you will need to use a motherboard that supports NC-SI
and also need to have a special cable. Please contact Supermicro at
to purchase the cable for this header. Refer to the table below for pin definitions.
MAC CODE IPMI CODE
SAN MAC BAR CODE
DESIGNED IN USA
BMC
FAN C FAN D
COM2
JPTG1
JRK1
S-UM12
JIPMB1
JVRM_SEL1
JWD1
BIOS
LICENSE
JSEN1
JSTBY1
M.2 CONNECTOR
JBT1
S-SGPIO
BT1
JSD1
JSD2
PCH
S-SATA4
JTPM1
S-SATA5
USB8 (3.0)
USB 2/3
USB 6/7 (3.0)
I-SATA4~7 I-SATA0~3 JPME2
FAN B LEDPWR
JPAC1
AUDIO_FP JHD_AC1 JF1
JL1
JSPDIF_IN1
NC-SI Header for IPMI Support
Pin Definitions
Pin# Definition
1 CLK_50MHz
3 NCSI_CRS_DV
5 NCSI_RXD0
7 NCSI_RXD1
9 NCSI_TXD0
11 NCSI_TXD1
13 NCSI_TX_EX
15 NC
17 5V STBY
19 5V STBY
21 5V STBY
JUIDB1
VGA
(UID)
LAN 2 LAN 1 USB 0/1
LEDM1
LED2
(UID-LED)
LAN
1
CTRL
FAN 4
JTBT1
JNCSI1
CPU2
JNVI2C2
JNVI2C1
CPU1
SP1
FAN A
FAN 2
58
Pin# Definition
2 Ground
4 Ground
6 Ground
8 Ground
10 Ground
12 Ground
14 NCSI_PRESENT_N
16 NC
18 5V STBY
20 5V STBY
22 NC
1. NC-SI Header for IPMI
COM1
IPMI_LAN
Support (JNCSI1)
USB 4/5 (3.0)
FAN 3
FAN 6
JPI2C1
JPWR4
JPWR3
JPWR2
JPWR1
FAN 5 FAN 1
www.supermicro.com