Supermicro X11DPG-QT User Manual page 16

Super X11DPG-QT User's Manual
I/O Devices
•
Serial (COM) Port
•
SATA 3.0
•
RAID (PCH)
Peripheral Devices
•
Two USB 3.0 ports on the rear I/O panel (USB4, USB5)
•
One internal USB 3.0 header with two (2) USB connections on the motherboard for front access (USB6, USB7)
•
One Type A USB 3.0 connector for front access (USB8)
•
Two USB 2.0 ports on the rear I/O panel (USB0, USB1)
•
One internal USB 2.0 header with two USB connections on the motherboard for front access (USB2, USB3)
BIOS
•
32MB SPI AMI BIOS
®
•
ACPI 3.0/4.0, USB keyboard, Plug-and-Play (PnP), SPI dual/quad speed support, riser-card auto detection support, and
SMBIOS 2.7 or later
Power Management
•
Main switch override mechanism
•
Power-on mode for AC power recovery
•
Intel Intelligent Power Node Manager 4.0 (Available when the Supermicro Power Manager [SPM] is installed and a special
power supply is used.)
•
Management Engine (ME)
System Health Monitoring
•
Onboard voltage monitoring for +3.3V, 3.3V standby, +5V, +5V standby, +12V, CPU core, memory, chipset, BMC, and
PCH voltages
•
CPU System LED and control
•
CPU Thermal Trip support
•
Status monitor for on/off control
•
CPU Thermal Design Power (TDP) support of up to 205W (See Note 1 on the next page.)
Fan Control
•
Fan status monitoring via IPMI
•
Dual cooling zone
•
Multi-speed fan control via onboard BMC
•
Pulse Width Modulation (PWM) fan control
Note: The table above is continued on the next page.
Motherboard Features
•
One Fast UART 16550 port on the I/O back panel
•
Eight SATA 3.0 connections supported by Intel PCH (I-SATA0~3, I-SATA4~7)
•
Two SATA 3.0 ports with power-pin built-in, w/support of Supermicro SuperDOM
(S-SATA4, S-SATA5)
•
RAID 0/1/5/10 (RSTe 5.x)
SM Flash UEFI BIOS
16