Table of Contents
Advertisement
Message
No.
Cool-down during
overheat idling
14
Water temperature
sensor error
15
Lock lever system
error
16
Travel 2-speed
system (switching)
17
AI system error
18
5V short-circuit
19
Problem or failure
(What happened)
The engine is forced to run
idling to avoid an overheat.
Water temperature sensor
error system is in trouble.
The lock lever system is in
trouble.
The 2-speed switching
system is in trouble.
The Auto Idle system is in
trouble.
The accelerator fails too.
The sensor's 5V power
supply is short-circuited.
Machine behavior
(Provisional measure)
Leave the engine idling until
this warning disappears.
Do not stop the engine
because otherwise coolant
becomes hot sharply and
may boil and gush out. Be
sure to cool down the engine
without stopping it.
The meter does not show
water temperature.
Press the display selector
switch, and the normal
display is switched back.
The machine's other
functions are operative, but
an overheat and other
problems cannot be
detected.
The engine can run, but the
machine fails to move.
The machine still runs at low
speed without switching to
high speed.
The machine's other
functions are still operative.
The accelerator fails, but the
machine's other functions
are still operative.
Move the machine to a place
suited for repair.
The majority of systems fail.
* The engine may get started
and the machine may move.
But do not try any jobs.
(Just move the machine to a
safe place.)
LIST OF SCREENS
Correction
Refill the radiator with
coolant by its boiled-over
amount. Unclog the radiator
and other components
before use again.
Check also the hydraulic
system for oil leak and other
troubles.
If an oil leak is found,
immediately contact your
local dealer for repair.
Immediately contact your
local dealer.
Immediately contact your
local dealer.
Immediately contact your
local dealer.
Immediately contact your
local dealer.
Immediately contact your
local dealer.
111
Advertisement
Table of Contents
