Checking And Adjusting The Auger/Impeller Cable; Checking The Auger-Gearbox-Oil Level - Toro Power Max 826 OE Operator's Manual

4. Tighten the jam nut
tension on the cable.
5. If the traction cable is properly adjusted but a problem
remains, contact an Authorized Service Dealer.
Checking and Adjusting the
Auger/Impeller Cable
Service Interval: After the first 2 hours—Inspect the
auger/impeller cable and adjust it if
necessary.
Yearly—Inspect the auger/impeller cable and adjust
or replace it if necessary.
1. Loosen the jam nut.
2. Engage the auger/impeller lever and hold it in place
(Figure 38).
3. Loosen or tighten the turnbuckle to adjust the spring
length to 7 cm (2.75 inches) as shown in
g019047
1. Jam nut
2. Turnbuckle
4. Tighten the jam nut
tension on the cable.
(Figure 37), ensuring there is slight
Figure 38
Figure
4
3
Figure 39
3. Spring
4. 7 cm (2.75 inches)
(Figure 39), ensuring there is slight
5. If the auger/impeller cable is properly adjusted but
a problem remains, contact an Authorized Service
Dealer.
Checking the
Auger-Gearbox-Oil Level
Service Interval: Yearly—Check the auger-gearbox oil and
1. Move the machine to a level surface.
2. Clean the area around the pipe plug
1. Pipe plug
3. Remove the pipe plug from the gearbox.
4. Check the oil level in the gearbox. The oil should be
39.
9.5 mm (3/8 inch) below the filler opening.
5. If the oil level is low, add GL-5 or GL-6, SAE 80-90
EP gear oil lubricant to the gearbox until the oil level is
9.5 mm (3/8 inch) below the filler opening.
Note: Do not use synthetic oil.
6. Install the pipe plug in the gearbox.
2
1
19
add oil if necessary.
(Figure
1
Figure 40
40).
G016782