Installing The Traction-Control Linkage - Toro Power Max 826 OE Operator's Manual

2
Installing the Traction-Control
Linkage
Parts needed for this procedure:
2 Hairpin cotter
3 Flat washer
Procedure
1. Insert the lower end of the rod into the lower link arm
so that the bent end of the speed-control rod faces
rearward (Figure 5).
g019004
2. Secure the lower end of the speed-control rod with a
flat washer and a hairpin cotter
3. Place a flat washer on the trunnion
1. Speed-selector lever
2. Trunnion
4. Shift the speed-selector lever into Position R2.
5. Rotate the lower link arm fully upward
(counterclockwise) as shown in
Figure 5
(Figure 5).
(Figure 6).
Figure 6
3. Inner washer
4. Outer washer
Figure 7.
6. Pull up on the speed-control rod and insert the
trunnion into the hole in the speed-selector lever
(Figure 6).
Note: If the trunnion does not fit into the hole
when you lift up on the speed-control rod, rotate the
trunnion upward or downward on the speed-control
rod until it fits.
7. Secure the trunnion and upper end of the speed-control
rod with a washer and a hairpin cotter.
Note: For easier installation, look down through the
opening in the speed selector
1. Speed selector
6
g019378
Figure 7
(Figure 8).
Figure 8