Checking The Engine-Oil Level; Checking The Tire Pressure; Checking The Skids And Scraper - Toro Power Max 826 OE Operator's Manual

Figure 11
5. Align the holes in the nested ends of the rods and
insert 2 carriage bolts (in the loose-parts bag) through
the short rod from the left side of the machine (from
the operating position).
6. Insert the cable clip that supports the deflector cable
onto the forward carriage bolt, and secure the carriage
bolts with locknuts from the loose-parts bag
12).
Figure 12
1. Cable clip
7. Hold the blue trigger cap down and rotate the Quick
Stick in a circle to ensure that the chute and deflector
operate smoothly.
g018885
(Figure
2. Deflector cable
5

Checking the Engine-Oil Level

No Parts Required
Procedure
Note: Your machine comes with oil in the engine
crankcase. Before starting the engine, check the oil level
and add oil if necessary.
Refer to Checking the Engine-Oil Level (page
6

Checking the Tire Pressure

No Parts Required
Procedure
The tires are overinflated at the factory for shipping. Reduce
the pressure equally in both tires to between 116 and 137
kPa (17 and 20 psi).
7
Checking the Skids and
Scraper
No Parts Required
Procedure
Refer to Checking and Adjusting the Skids and Scraper (page
18).
8
17).