Table Of Contents; Safety - Toro Power Max 826 OE Operator's Manual

Remove the kit from the engine and restore the engine
to its original factory configuration when running the
engine under 1500 m (5,000 ft). Do not operate an engine
that has been converted for high-altitude use at lower
altitudes; otherwise, you could overheat and damage
the engine.
If you are unsure whether or not your machine has been
converted for high-altitude use, look for the following
label (Figure 3).
This spark ignition system complies with Canadian ICES-002.
Contents
Introduction .................................................................. 1
Safety ........................................................................... 2
Safety and Instructional Decals ................................. 3
Setup ............................................................................ 5
1 Installing the Upper Handle.................................... 5
2 Installing the Traction-Control Linkage.................... 6
3 Installing the Chute ............................................... 7
4 Installing the Chute-Control Rod ............................ 7
5 Checking the Engine-Oil Level ............................... 8
6 Checking the Tire Pressure ..................................... 8
7 Checking the Skids and Scraper ............................... 8
8 Checking the Operation of the Traction
Drive ................................................................. 8
Product Overview .........................................................10
Operation ....................................................................10
Before Operation ......................................................10
Safety....................................................................10
Freewheeling or Using the Self-propel Drive...............10
Filling the Fuel Tank ...............................................11
During Operation .....................................................11
Safety....................................................................11
Starting the Engine .................................................12
Shutting Off the Engine ..........................................13
Operating the Traction Drive ...................................14
Operating the Speed Selector ...................................14
Operating the Auger/Impeller Drive.........................14
Operating the Quick Stick®.....................................15
Unclogging the Discharge Chute ..............................15
Operating Tips ......................................................16
After Operation ........................................................16
Safety....................................................................16
Preventing Freeze-up after Use.................................16
Maintenance .................................................................17
Figure 3
Recommended Maintenance Schedule(s) ......................17
Maintenance Safety.................................................17
Preparing for Maintenance.......................................17
Checking the Engine-Oil Level.................................17
Checking and Adjusting the Skids and
Scraper ..............................................................18
Checking and Adjusting the Traction Cable ................18
Checking and Adjusting the Auger/Impeller
Cable ................................................................19
Checking the Auger-Gearbox-Oil Level .....................19
Changing the Engine Oil .........................................20
Lubricating the Hex Shaft ........................................20
Replacing the Spark Plug .........................................21
Adjusting the Discharge-Chute Latch ........................22
Replacing the Drive Belts.........................................22
Storage ........................................................................22
Preparing the Machine for Storage ............................22
Removing the Machine from Storage.........................22
Troubleshooting ...........................................................23

Safety

This machine complies with ANSI B71.3 specifications
in effect at the time of production.
•
Read and understand the contents of this Operator's
Manual before you start the engine. Ensure that everyone
using this product knows how to use the product and
understands the warnings.
•
Do not put your hands or feet near moving components
on the machine.
•
Do not operate machine without all guards and other
safety protective devices in place and working on the
machine.
•
Keep clear of any discharge opening. Keep bystanders a
safe distance away from the machine.
•
Keep children out of the operating area. Never allow
children to operate the machine.
•
Shut off the engine before unclogging, servicing, or
fueling the machine.
You can find additional items of safety information in their
respective sections throughout this manual.
2