General Information About Radio Operation - HomeMatic HmIP-FAL230-C10 Installation And Operaion Manual

General information about radio operation

and dry. Do not use any detergents containing solvents,
as they could corrode the plastic housing and label.
13 General information about radio
operation
Radio transmission is performed on a non-exclusive
transmission path, which means that there is a possibil-
ity of interference occurring. Interference can also be
caused by switching operations, electrical motors or de-
fective electrical devices.
The range of transmission within buildings can
differ greatly from that available in the open air.
Besides the transmitting power and the reception
characteristics of the receiver, environmental
factors such as humidity in the vicinity have an
important role to play, as do on-site structural/
screening conditions.
eQ-3 AG hereby declares that this device complies with
the essential requirements and other relevant regulations
of Directive 1999/5/EC.
You can find the full declaration of conformity at www.
eQ-3.de.
78
14 Technical specifications
Device short description:
Construction of the
regulation and control device:
Number of heating zones:
Number of actuators:
Number of pumps:
Supply voltage:
Current consumption:
Switching capacity per heating
zone:
Nominal load of all actuators:
Type of disconnection:
Cable type and cross section:
Cable cross section of cable
bushing 1:
Cable cross section of cable
bushing 2:
Cable cross section of cable
bushing 3:
Degree of protection:
Protection class:
Ambient temperature:
Type:
Technical specifications
HmIP-FAL230-C10
independently
mounted electronic
regulation and control
device, surface mount
10
15 / (14)
1
230 V/50 Hz
6.3 A max.
1 A max.
250 W max.
micro
rigid and flexible cable,
0.75 - 1.5 mm²
> 5.2 mm
> 8.2 mm
> 3.2 mm
IP20
I
0 - 50°C
1.B.
79