Pairing With A Homematic Ip Wall Thermostat; Pairing With A Homematic Ip Multi Io Box - HomeMatic HmIP-FAL230-C10 Installation And Operaion Manual

Start-up
and enable it to communicate with other devices, you
must teach it in first.
You can either pair the floor heating actuator directly with
other Homematic IP devices (e.g. the wall thermostat or
the Multi IO Box) or teach it in to the Homematic IP Ac-
cess Point. After pairing, the device is configured at the
wall thermostat. After teaching-in to the Access Point, the
device is configured via the Homematic IP app.
6.4.1

Pairing with a Homematic IP Wall Thermostat

Please make sure you maintain a distance of at
least 50 cm between the devices.
You can cancel the pairing procedure by briefly
pressing the system button (A) again. This will be
indicated by the device LED (A)lighting red.
If no pairing operations are carried out, pairing
mode is exited automatically after 3 seconds.
If you want to pair the floor heating actuator with a
Homematic IP Wall Thermostat, the pairing mode of both
devices has to be activated first. To do this, proceed as
follows:
• Select the channel for pairing a device by press-
ing the select button (B) briefly (see fig. 7). Press
once for channel 1, twice for channel 2 etc. The
58
channel LED lights permanently for the corre-
sponding channel.
• Press and hold down the system button (A) for 4
seconds until the LED quickly starts flashing or-
ange (see fig. 7). The pairing mode of the selected
channel remains activated for 3 minutes.
• Press and hold down the system button of the
wall thermostat for at least 4 seconds to activate
the pairing mode. The device LED flashes orange.
The device LED (A) lights up green to indicate that pairing
has been successful.
If pairing failed, the device LED (A) lights up red. Please
try again.
6.4.2

Pairing with a Homematic IP Multi IO Box

If you want to pair the floor heating actuator with a
Homematic IP Multi IO Box, the pairing mode of both
devices has to be activated first. To do this, proceed as
follows:
• Briefly press the select button (B) until the LEDs of
all channels light up green (see fig. 7).
Press and hold down the system button (A) for 4
•
seconds until the LED quickly starts flashing or-
ange (see fig. 7). Pairing mode remains activated
for 3 minutes.
• Press and hold down the system button of the
Multi IO Box for at least 4 seconds to activate the
Start-up
59