10.3.2 Flashing Sequences Of The Channel Led; Restore Factory Settings; Maintenance And Cleaning - HomeMatic HmIP-FAL230-C10 Installation And Operaion Manual

Troubleshooting

10.3.2 Flashing sequences of the channel LED

Flashing code Meaning
Slow Emergency op-
flashing eration activated
Short double Radio connec-
flashing tion to wall ther-
mostat failed
76
Solution
Change batteries
of the wall
thermostat,
perform a
communication
test, re-position
the wall
thermostat (if
required), replace
wall thermostat if
defective
Re-position wall
thermostat or
add a repeater
(see sec. „10.1
Command not
confirmed" on
page 72).
11

Restore factory settings

The factory settings of the device can be re-
stored. If you do this, you will lose all your set-
tings.
To restore the factory settings of the floor heating
actuator, please proceed as follows:
• Press and hold down the system button (A) for 4
seconds until the LED quickly starts flashing or-
ange (see fig. 7).
• Release the system button again.
• Press and hold down the system button again for
4 seconds, until the status LED lights up green.
• Release the system button to finish the proce-
dure.
The device will perform a restart. After the restart, you
can again integrate your device into your Homematic IP
system.
12

Maintenance and cleaning

The product does not require any maintenance.
Enlist the help of an expert to carry out any main-
tenance or repairs.
Clean the device using a soft, lint-free cloth that is clean
Restore factory settings
77