Configuration Via The Homematic Ip Wall Thermostat - HomeMatic HmIP-FAL230-C10 Installation And Operaion Manual

Configuration via the Homematic IP Wall Thermostat

• Your device will automatically appear in the
Homematic IP app.
• To confirm, please enter the last four digits of the
device number (SGTIN) in your app or scan the
QR code. Therefore, please see the sticker sup-
plied or attached to the device.
• Please wait until teach-in is completed.
• If teaching-in was successful, the LED lights up
green. The device is now ready for use.
• If the LED lights up red, please try again.
• Select the desired solution for your device.
• In the app, give the device a name and allocate
it to a room.
7 Configuration via the Homematic
IP Wall Thermostat
The Homematic IP Floor Heating Actuator can be
configured via the Homematic IP Wall Thermo-
stat (HmIP-WTH-2), via the Homematic IP Access
Point together with the smartphone app or via
the WebUI of the Homematic Central Control
Unit CCU2.
To configure the floor heating actuator using the wall
thermostat, please proceed as follows:
• Press and hold down the control wheel of the
wall thermostat to open the configuration menu.
62
Configuration via the Homematic IP Wall Thermostat
• Select the symbol by turning the control
wheel and confirm by pressing the control wheel
briefly.
• If the wall thermostat is connected to more than
one floor heating actuator, please select the re-
quired floor heating actuator using the control
wheel.
• Please define if you want to configure the device
parameters ("UnP1/UnP2") or the channel param-
eters ("ChAn").
All the settings that are made under "UnP1/UnP2"
will be applied to the entire device. All settings
that are made under "ChAn" will be applied to the
single channels of the device.
• You can individually adjust the line-up time/fol-
low-up time, eco temperatures, intervals etc. ac-
cording to the following table.
63