Adding A New Floor Heating Actuator; Teaching-In To The Homematic Ip Access Point - HomeMatic HmIP-FAL230-C10 Installation And Operaion Manual

Start-up
pairing mode. The device LED flashes orange.
The device LED (A) lights up green to indicate that pairing
has been successful.
If pairing failed, the device LED (A) lights up red. Please
try again.
6.4.3

Adding a new floor heating actuator

To add a new floor heating actuator to the system or to
the existing devices, please proceed as follows:
• First pair the new floor heating actuator with an
existing one. Activate the pairing mode of the
existing floor heating actuator. Therefore, press
and hold down the system button (A) for at least
4 seconds.
• Activate the pairing mode of the new floor heating
actuator. Press and hold down the system button
(A) for at least 4 seconds.
The device LED (A) lights up green to indicate that
pairing has been successful. If pairing failed, the
device LED (A) lights up red. Please try again.
• You can add the new floor heating actuator to
other devices such as the wall thermostat or the
Multi IO Box. Simply activate the pairing mode of
the floor heating actuator first and of the device
you want to pair afterwards. For further informa-
60
tion, please refer to the user manual of the corre-
sponding device.
6.4.4

Teaching-in to the Homematic IP Access Point

First set up your Homematic IP Access Point via
the Homematic IP app to enable operation of
other Homematic IP devices within your system.
For further information, please refer to the
operating manual of the Access Point.
You can connect the device either to the Access
Point or to the Homematic Central Control Unit
CCU2. For detailed information, please refer to
the Homematic IP User Guide, available for down-
load in the download area of www.eQ-3.de.
To teach-in your floor heating actuator to the Access
Point, please proceed as follows:
• Open the Homematic IP app on your smartphone.
• Select the menu item "Teach-in device".
• Briefly press the system button (A) until the LED
quickly starts flashing orange (see fig. 7). The
teach-in mode of the selected channel remains
activated for 3 minutes.
You can manually start the teach-in mode for an-
other 3 minutes by pressing the system button (A)
briefly (see fig. 7).
Start-up
61