Manual Operation; Switch Heating Zones On/Off; Activating/Deactivating The Pump Control - HomeMatic HmIP-FAL230-C10 Installation And Operaion Manual

Manual operation

Heating P053
in heating
mode
Configuration P054
for rooms
Selection P055
of heating
system
For further information regarding the configura-
tion, please refer to the user manual of the
Homematic IP Wall Thermostat (HmIP-WTH-2).
8 Manual operation
8.1

Switch heating zones on/off

For installation and tests you can manually switch single
heating zones on or off. To switch single heating zones
on or off, please proceed as follows:
• Select the required channel using the select but-
70
0 Heating in heating
mode deactivated
1 Heating in heating
mode activated
(default)
0 Default room
1 Room with fireplace
2 Room with towel
radiator
0 Standard floor
heating (default)
1 Low energy floor
heating
2 Radiator
3
Passive convector
4 Active convector
ton (B) (see fig. 7).
• Press the select button until the LED (B) flashes
green three times.
The channel will be switched on or off for 15 minutes.
Afterwards, normal operation will be continued for the
heating zone.
8.2

Activating/deactivating the pump control

If you want to use connection terminal (H) for controlling
a heating pump, the heating zone can be switched to
pump control directly via the device. To do this, proceed
as follows:
Press the select button (B) until the LED of chan-
•
nel 1 starts flashing green (see fig. 7).
If the LED of channel 1 starts flashing slowly, the
pump control is activated. If the LED of channel 1
starts flashing quickly, the pump control is deac-
tivated.
• If you do not want to change any parameters, you
can exit the menu by pressing the select button
(B) briefly.
• To switch the parameter from activated to de-
activated or from deactivated to activated, press
and hold down the select button (B) for at least
4 seconds.
Manual operation
71