AEG PRO COMBI BS1830470X User Manual page 48

48 www.aeg.com
This is not the end of
the cleaning
procedure. Follow
the message in the
display to complete
the cleaning.
d) Wipe the internal surface of the
appliance with a non-abrasive
surface care sponge. You can use
warm water or oven detergents
to clean the cavity.
e) Press
The final part of the procedure
starts. The duration of this stage
is around 25 minutes.
3. Wipe the internal surface of the
appliance with a non-abrasive surface
care sponge. You can use warm
water to clean the cavity.
After cleaning keep the appliance door
open for approximately 1 hour. Wait until
the appliance is dry. To speed up the
drying you can heat up the appliance
with hot air at temperature 150 °C for
approximately 15 minutes. You can get
maximum effects of the cleaning function
if you manually clean the appliance
immediately after the function ends.
12.5 Cleaning Reminder
This function reminds you that the
cleaning is necessary and that you should
perform the function: Steam Cleaning
Plus.
You can enable / disable the function:
Cleaning Reminder in the menu: Basic
Settings.
12.6 Steam generation system
- Descaling
When the steam generator operates,
there is an accumulation and deposition
of limestone inside because of calcium
contents in the water. This can have a
negative effect on the steam quality, on
the performance of the steam generator
and on the food quality. To prevent this,
clean the steam generation circuit from
residual stone.
Remove all accessories.
.
Select the function from the menu:
Cleaning. The user interface will guide
you through the procedure.
The duration of the complete procedure
is about 2 hours.
The light in this function is off.
1. Make sure that the water drawer is
empty.
2. Press
.
3. Put the grill- / roasting pan on the
first shelf position.
4. Press .
5. Put 250 ml of the descaling agent in
the water drawer.
6. Fill the remaining part of the water
drawer with water to the maximum
level until the acoustic signal sounds
or the display shows the message.
7. Press .
This activates the first part of the
procedure: Descaling.
The duration of this part is
around 1 hour 40 minutes.
8. After the end of the first part, empty
the grill- / roasting pan and put it on
the first shelf position again.
9. Press .
10. Fill the water drawer with fresh water
to the maximum level until the
acoustic signal sounds or the display
shows the message.
11. Press
.
This activates the second part of the
procedure: Descaling. It will rinse the
steam generation circuit.
The duration of this part is
around 35 minutes.
Remove the grill- / roasting pan after the
end of the procedure.
If the function: Descaling is
not performed in the correct
way, the display will show a
message to repeat it.
If the appliance is humid and wet, wipe it
out with a dry cloth. Let the appliance
dry fully with the door open.